To order:
- Using the Selection Guide,
fill in the 2nd and 3rd digits to identify the elastomer and its corresponding
conductive particle.
- The 4th digit is always 5 to
identify Molded Gasket.
- Use the 5th digit to
identify the part shape:
0 Rectangular
1 Square 2 Ring
3 Special
- Use the 6th digit to
identify the wall cross-section:
1 Round
2 "D" shape 3 "U" shape
4 Rectangular or Square 5 "T" shape
6 Special
- Leave the 7th and 8th digits
as XX. CSI will assign a sequential part number.
- Use the 9th and 10th digits
to identify Shore A durometer of the elastomer from the Selection
Guide.
Example: To order
Multi-Point VI-SPG molded gaskets, of
rectangular shape with a round wall crosssection, silicone elastomer, 80
durometer; order 6265-01 XX-80. |